Any one see them? Havea pic?
Got no camera (or the tech) to post.
I love pic too. 8^ (
I got some for
1/4, 20; 11/16ths below the lock washer, suckerhead allen
but have not pulled out to ck (ol v/c is still on there).
Post up one if U got 'em
- -Chad
✓
yes, we discussed. I must have not seen them rolled up in the paper, thrown them out. 1/4, 20 is good. I think 11/16 (after a lock washer or something?) is good on length. Do they need a lock? thread lock fluid? any spec attention? Rather hassle w/that than ground a deeper hole in the vc each time I 'close up'.
For the carb hat, I’ve used a 1/4-20 bolt with an Allen head. Don’t remember the length. I already put the bolts in the mail for the v/c
"...Did I send you a set yet?..."
Oh buddy, dont worry bout it. I'd rather talk about Norfolk back in the day !
Truth (more of it, anyway) I don't think so. What do THESE look like, gota pic? Specs?
Got another item round there? A shaft to hang the carb hat (would it B threaded at each end?) May B a non-phalic (aahah!) nut for the end? I was thinkin this one but would hafta mill out the center, do so w/a sloping "V" wall, etc. Knock off a good portion of those nice fins, hey?
Did I send you a set yet? I have a set sitting here ready to send